Flat roof repair in Lubbock
Nothing on the South Plains is truly flat, roofs included. A low slope roof sheds water slowly, so the small faults that a pitched roof shrugs off sit in standing water instead.
The short answer
Most flat roof leaks around Lubbock come from three places: a seam or blister in the membrane, a blocked scupper or drain that lets water pond, or the curb under a swamp cooler. A sound membrane with one bad spot is a repair. Wet insulation underneath or splits across the field usually means a recover or a new roof.
Where the low slope roofs are
Most Lubbock houses carry a pitched shingle roof, but a surprising number have a flat section somewhere on them. It is the den or the extra bedroom added onto a ranch house in the seventies, tied in under the main eave. It is the carport, the patio cover and the garage roof that runs out behind. In Ransom Canyon some houses were designed with low slope roofs from the start. In town, older shops and offices along the main roads and around the Depot District are mostly flat behind their parapets.
That matters because a low slope tie in is often where the leak lives. Where a flat addition meets the shingles of the main house, the two roofs move differently in the heat and the joint between them opens up first.
What the covering is made of
Knowing the material changes the conversation, and you can usually tell from a ladder at the edge.
- Built up roof. Layers of felt and asphalt, often with gravel on top. Common on older houses and shops. It fails slowly, usually at blisters and cracked edges.
- Modified bitumen. Rolls of asphalt sheet, often with a granule face, laid in overlapping strips. The seams are the weak point.
- Single ply membrane. A white or grey sheet such as TPO, or black rubber such as EPDM. Common on newer commercial roofs and some additions. Splits and seams are what to look for.
- Rolled roofing. A cheap granule roll nailed down in one layer. It is often what sits on a carport, and it rarely lasts long in this sun.
Why they leak here
Ponding. Rain on the South Plains tends to arrive all at once in a thunderstorm. A low roof with a sagging deck or a drain set a little high holds that water in a puddle for days. The puddle finds the weakest seam.
Blocked scuppers. Spring dust, tumbleweed fragments and leaves from the yard collect at the one outlet the roof has. A scupper that clogs turns a light shower into a pool that rises over the flashing.
Sun and heat. A dark membrane under the West Texas sun runs far hotter than the air, then cools fast at night. Asphalt surfaces dry out and crack in a pattern like alligator hide, and seams pull apart a little more every season.
The swamp cooler curb. Many coolers here sit on the flattest part of the roof. The curb they stand on, the water line and the drain all cross the membrane, and the vibration works at every seal. A slow drip that appears only in summer is very often the cooler rather than the roof.
Hail. A big stone can crack a membrane over a screw head or bruise a felt surface without any obvious hole. Read how hail damage shows up on a South Plains roof before deciding whether a claim is the right route.
Patch, recover or replace
A flat roof repair is a patch over one fault: a split seam, a blister, a torn flashing. It is the right answer when the covering around the fault is still stuck down and the insulation underneath is dry.
The test that decides it is moisture. Water that gets under a membrane soaks into the insulation board and can sit there for months, out of sight. A careful roofer will press the surface for soft spots, cut a small core, or use a moisture meter before quoting. If the board is wet across a wide area, a patch only traps the water.
Where the deck is sound and only the top layer is worn, a recover lays a new covering over the old one. Building codes limit how many coverings a roof may carry, so a roof that has already been recovered once usually needs a full tear off next time. When that is where you are, the roof replacement page covers what a tear off involves here.
Before you call someone
Go into the room under the leak after rain and note where the stain is and how big it gets. From a ladder, look at the scupper or drain and clear anything sitting in it. Take a photograph of the roof surface if you can do so safely, and of the swamp cooler curb. Those few things let a roofer tell you on the phone whether it sounds like a patch, and they keep the first visit short.
Texas does not license roofers, so the checks fall to you. The page on how to check a roofing company in Texas sets out what to ask for. Most local companies offer free estimates. For a leak on the pitched part of the house rather than the flat section, the roof repair page covers the usual suspects.
Questions people ask
- Is it normal for water to sit on a flat roof after rain?
A little, briefly, yes. Water still standing two days after the rain stops is ponding, and it is worth fixing. It loads the deck, wears the surface faster and finds any weak seam. The cause is usually a sagging deck or a drain set too high, not the membrane.
- Can a flat roof be coated instead of replaced?
Sometimes. A coating can add years to a membrane that is still dry underneath and stuck down well. It does nothing for wet insulation or a rotten deck, so ask how the roofer checked for moisture before they quoted a coating.
- Does hail damage a flat roof?
It can, and it is harder to see than on shingles. Hail bruises the felt under a granule surface and can crack a single ply membrane over a hard spot. After a big storm, ask for close photographs of the surface and of any metal edge or vent, since dents there help date the damage.
- Who should look at a leak under the swamp cooler?
Often both trades. The roofer deals with the curb and the flashing around it, and the cooler technician with the pan, float and drain line. If the leak only shows when the cooler runs, start with the cooler; if it shows after rain with the cooler off, start with the roof.